The Tower
Cited by 12 Concordances Compliant with Ordinance 4 Surveyed — partially ISO 8,812 — pending since 11,904

Secondary Conduit

MS 5309.14 · Practices and doctrines

Definition and Scope

Secondary Conduit is a designation applied to any pneumatic line that departs from a primary trunk of the Great Pneumatic Tube Network and serves a terminal destination — a department, guildhall, archival atrium, receiving bay, or individual workroom — rather than a district. The term is codified in the Manual for Anomalous Conduits, Revision 89, which classifies Secondary Conduits as a subspecies of the Pneumatic Conduit Array and distinguishes them from primary trunks by bore (typically 0.18 to 0.45 metres), by pressure differential, and by the administrative fact that they terminate.

The Tower contains an estimated 4,100 secondary conduits in active service. Their numbering follows the Conduit Specification and is assigned at the point of departure, not at the point of arrival; a conduit numbered at Floor 89 may serve a room on Floor 212. This has produced persistent confusion among visiting clerks and is the subject of standing corrective notices posted at each Apertural Relay.

Nomenclature

Secondary conduits are designated by a three-part string: the departure floor, a Greek letter indicating the branch order (alpha for a first-order branch, beta for a second, and so forth), and a sequential integer. Thus 107-delta-1 denotes the first conduit of fourth-order branching from Floor 107 — the line also known as The Specimen Stair. Deviations from this scheme are numerous and grandfathered: Conduit Alpha, for example, predates the current specification entirely and retains its name by exception recorded in the Third Concordance.

Ancillary lines of service bore (1.4 to 2.2 metres) used for upkeep of adjacent primary works are classified as Maintenance Shaft rather than as secondary conduits, notwithstanding that they run alongside them and often share brackets. The distinction is operational: a secondary conduit moves objects; a maintenance shaft moves staff, ladders, and — on the older floors — considerable quantities of dust.

Whispering Subspecies

A subset of secondary conduits exhibits acoustic emission during transit, producing a low vocal quality in the line that technicians have classified as a Whispering Conduit. These are catalogued as a subspecies of the Pneumatic Conduit Array under Revision 89 and are subject to additional inspection intervals. The Guild of Conduit Technicians maintains that whispering is an artifact of bore irregularity and that it can be cured by reaming; the Guild of Conduit Tenders maintains that reaming silences a conduit that has not finished speaking and that the correct procedure is to wait.

Reconciliation of these positions has been attempted four times, most recently under the Second Concordance's Annex 11, which recommends "either remedy, recorded as applied." No floor has yet reported satisfaction with this wording.

Administrative Jurisdiction

Primary trunks and their branch points fall under joint administration by the Guild of Conduit Technicians and the Guild of Conduit Tenders. Secondary conduits beyond the branch point pass to local custody: the department or guildhall they serve is responsible for their upkeep, with the notable exception of any line running through a secondary atrium, where the Atrium Curators hold authority except where the line lies on the route of a Pneumatic Conduit Array conduit. Lines serving the waste stream are removed from this scheme entirely and administered under Waste Reclamation Directive 88 by the Department of Verification and the Department of Reclamation.

The practical effect is that a single physical line may change hands three times between its origin and its terminus, and often does. The winter of the long inventory on Floor 89 produced forty-one disputes on this point alone, of which nine remain open under the Fourth Concordance.

Contested Boundaries

There is unresolved disagreement over what constitutes a secondary conduit where a line serves two destinations in series. The Conduit Specification treats the segment between the first and second destination as primary (since it does not terminate), while the Manual treats it as secondary (since it was branched). This disagreement is ordinarily invisible until a fault occurs and two offices arrive with different claim forms.

The departmental boundary cases — notably Spiral 7 Aperture 42 and the branch feeding Receiving Bay Gamma from Aperture 77-Gamma — are cited in both directions as precedent, which is why neither has been cited as settling the question. A proposed codification circulated in the autumn of the recording year was returned by the scriptoria with the marginal note that it "would require the Tower to decide where a line ends," and no further action has been taken.

Inspection and Prohibition

Secondary conduits are inspected at intervals proportional to their length and inversely proportional to the sensitivity of what they carry. Lines serving scriptoria are inspected twice yearly; lines serving the specimen stores of Floor 107 are inspected monthly. The standing prohibition on leaning against a secondary conduit in a public corridor dates from the collapse of a bracket on a fourth-order branch during a procession and remains in force.

Carriers may not be placed in a secondary conduit for transport between two rooms on the same floor. This rule is enforced by the Conduit-Tenders on duty and is, by universal account, the most reliably enforced regulation in the Tower.

See also

Referenced by

Readers also asked

Department of Verification: who are they?

Department of Verification was a primary administrative body charged with the definitive assessment of an applicant's substantive existence, preceding the establishment of the modern Department of Ontic Verification and …

Department of Verification
Department of Reclamation: who are they?

The Department of Reclamation is the primary executive body responsible for the re-appropriation, nullification, and archival recycling of concepts, objects, and spaces determined to be ontologically surplus or procedura…

Department of Reclamation
Conduit Alpha: what is it for?

Conduit Alpha is the primary trunk of the Pneumatic Conduit Array, a titanium-alloy cylinder of 1.2 meters internal diameter that traverses approximately 3,000 vertical floors of the Tower, linking major sorting atria an…

Conduit Alpha
Pneumatic Conduit Array: what is it for?

The Pneumatic Conduit Array is the primary infrastructural complex responsible for the internal transportation of urgent dossiers, priority manifests, and other standardized artifacts through the central column of Centra…

Pneumatic Conduit Array
Assistance

A Librarian is with you.

MS 9679.39
MS 8532.92
MS 1913.80

The Librarian considers the matter closed.

Typical response time: one Concordance. If your enquiry concerns a holding, consult the finding aid.