Dampening Coefficient (δ)
MS 1422.68 · Practices and doctrines
Definition and notation
The Dampening Coefficient (δ) is the scalar quantity by which a phenomenon's unattenuated signature is multiplied—never divided, except under provisional conditions—before the signature is released from a dampening field. It is recorded to four decimal places and reported to three, the fourth being retained in the working ledger for the purposes of appeal. Values below 0.2000 are described in the Dampening Protocols as "quiet"; values above 0.8500 as "loud, and the reader is asked to proceed by an adjacent corridor."
δ is distinguished from the Drift Coefficient, with which it shares a symbol and no other property. The Drift Coefficient measures lateral displacement of a signature across a floor's stairwell margin; the Dampening Coefficient measures vertical attenuation across the thickness of the field. The two are routinely confused in correspondence, and the Bureau of Resonance Dampening has twice declined to assign a new symbol on the grounds that the confusion is "administrative rather than physical."
Placement in the standardized protocols
δ is assigned at the third stage of any protocol that passes through Contextualization. Contextualization establishes what the phenomenon is understood to be; the dampening coefficient establishes how much of that understanding survives the field. The order is not reversible. An uncontextualized signature has no denominator against which attenuation can be measured, and the resulting figure—known in the Bureau's jargon as an orphan value—cannot be entered in the ledger at all but is kept in a separate drawer on the ninth landing.
The Mass Coefficient and the Coincidence Coefficient are computed independently of δ and then reconciled against it. Reconciliation is formal rather than arithmetical; a reconciliation that produces an exact match is treated as evidence that one of the three was derived by shortcut and is audited accordingly. The Lambda Coefficient governs temporal precision in these reconciliations only, and no entry may be made in ink not certified under its provisions.
The directive of 1344 and the dispute over bases
"The coefficient shall be expressed against a stated basis, and no basis shall be presumed where it has not been sealed in the presence of the Bureau's clerk of measurement."
— Directive of 1344, Clause 6
The Directive settled the earlier practice of reporting δ as a bare figure, but left unresolved what the basis should be. Two recensions persist. The first, defended in the Annotated Dampening Protocols, Second Recension, holds that the basis is the signature as measured at the aperture margin before the field is raised. The second, defended at length in On the Measurement of Envelope Thickness, holds that the basis is the signature as it would have been had no field been raised—the counterfactual reading. The two readings coincide in the laboratory and diverge by as much as 0.31 under floor conditions, which is to say under every condition in which the number is actually used.
The Bureau has not resolved the question. By Memorandum of the Ninth Landing it instead requires that both figures be recorded, side by side, in columns headed A and B, and that the column in which a given figure originated be indicated by an asterisk. Nothing is indicated when the figure appears in both columns. Travelling auditors have complained that this convention is illegible at a glance; the Bureau's answer, recorded in its minutes for the winter sitting of that year, is that the convention is not intended to be read at a glance.
Worked example: the Trembling Censer
In 1389 a thurible of plain brass on Floor 42 was observed to swing without being swung. Detection preceded Contextualization by some nine days, an unusually long interval once attributed to the reluctance of the incumbent—the clerk Melisandre Vow, whose repeated requests for a second pair of hands were returned to her endorsed "not required" in a hand she later identified as her own. The signature was measured at the aperture margin at 1.0000 and released at 0.2300, giving δ = 0.2300.
Vow's grievance concerned not the value but its recording. Clause 6 obliged her to state the basis; she stated the counterfactual, was overruled by the Sub-Bureau of the Margin, and entered column A. The censer continued to swing throughout. When asked some years later what had been dampened, she gave the reply now carved above the door of the measurement room on that floor: "The noise of it, not the swinging, and I was not consulted as to which."
Later instrumentation
From the middle of the sixteenth century δ was read from the Threshold Dampening Field apparatus by the deflection of a suspended brass index, and reported on a graduated strip of paper pasted, then re-pasted, along the frame. The paper has been replaced on average once every eleven years; the brass index has not been rehung since 1602, following an incident whose particulars are no longer legible but whose outcome, per a notice fixed to the frame, is that the index is not to be polished.
Where phenomena are assessed collectively rather than one by one, the coefficient is aggregated under the Conceptual Dampening Fields procedures, and the resulting field value carries the lowest individual δ in the group rather than the mean. The choice has been challenged twice before the Committee on Aggregation Methods and upheld both times on the reasoning that a mean gives a field credit it has not earned.
Criticism and the borrowed figure
The most persistent criticism of δ is that a coefficient so often near 0.5000 invites the suspicion of having been supplied rather than measured. The Borrowed Coherence Coefficient is sometimes pointed to as evidence that the Bureau's numbers circulate more freely than its seal permits. The Bureau's position, stated in a circular of the standing committee and never since amplified, is that a borrowed figure is still a figure and the borrower is nonetheless answerable for the basis.
The worked example cited in the Bureau's own manual, at §12, is δ = 0.5000, and the manual does not give the phenomenon to which it belongs. This is not an oversight; the manual, when pressed, says only that the example is "illustrative in the strict sense."
See also
See also
-
MS 8248.38
Polian Coefficient
The Polian Coefficient is the standard dimensionless value, expressed as a real number, that quantifies the strength of a subject'…
-
MS 7303.14
Acoustic Signature
An acoustic signature is the unique and persistent spectral resonance profile of an object, event, or phenomenon, as formally reco…
-
MS 6011.37
Application of Dampening Coefficients
The Application is never performed in isolation. It is preceded by the Detection and Contextualization stages of Protocol Sigma-7.…
-
MS 8950.19
Ludlow Unit
The Ludlow Unit (abbreviated Ld) is the Tower's principal measure of cognitive dampening, defined as the attenuation in noetic tra…
-
MS 9700.25
Polian Coefficient Object
Polian Coefficient Object is the archival designation for any subject whose Polian Coefficient has been formally registered, seale…
-
MS 9580.75
Annex III: Phenomenological Legibility
"A coefficient that cannot be written is not a coefficient; it is an opinion with a decimal point."…
Referenced by
- MS 3683.60 Ledger of Damped Echoes
- MS 9443.43 Signature Attunement
- MS 9185.25 Coefficient Registry
- MS 7400.29 Bureau of Dampening Protocols
Readers also asked
Coincidence Coefficient: how is it conducted?
The Coincidence Coefficient is a dimensionless quantity, denoted k, expressing the proportion of a given event, pairing, or arrangement that may be attributed to coincidence rather than to intent, structure, or the ordin…
Coincidence CoefficientContextualization: how is it conducted?
Contextualization is the second procedural stage in numerous standardized protocols within the Tower, most prominently Protocol Sigma-7, where it serves as the critical bridge between the initial detection of a phenomeno…
ContextualizationProvisional Coefficient Assignment: how is it conducted?
Provisional Coefficient Assignment is the administrative procedure by which a coefficient is attached to a holding, floor, door, or office before the coefficient in question has been measured. It is distinguished from or…
Provisional Coefficient AssignmentThreshold Dampening Field: what is it for?
The Threshold Dampening Field is a temporary barrier erected during the containment stage of dampening, and the first stage of Contextual Dampening. Its function is to isolate the subject's floor — or, in the case of a s…
Threshold Dampening FieldPassages cited from this record
-
The coefficient shall be expressed against a stated basis, and no basis shall be presumed where it has not been sealed in the presence of the Bureau's clerk of measurement.
Directive of 1344, Clause 6
Readers who consulted this also failed to find
- MS 5942.17 Committee on Aggregation Methods
- MS 4241.98 Annotated Dampening Protocols, Second Recension
- MS 6188.49 Memorandum of the Ninth Landing
- MS 5255.66 On the Measurement of Envelope Thickness
Because you consulted